Recording a picture – Sony DCR-TR7000 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
— Recording - Basics —
Recording a picture
Your camcorder automatically focuses for you.
(1)
Remove the lens cap by pressing both knobs on its sides and attatch the lens
cap to the grip strap.
(
2
)
Install the power source and insert a. cassette. See "Step 1" and "Step 2" for
more information (p. 8 to 12).
(3)
Set the POWER switch to CAMERA while pressing the small green button.
(4) Turn STANDBY to STANDBY.
(5)
Press START/STOP. Your camcorder starts recording. The "REC" indicator
appears. The camera recording lamp located on the front of your camcorder
lights up. To stop recording, press START/STOP again.
... . ^
1
I
2
Note
Fasten the grip strap firmly. Do not touch the built-in microphone during recording.
To enable smooth transition
You can make the transition between the last scene you recorded and the next scene
smooth as long as you do not eject the cassette. When you exchange the battery pack in
the recording mode, set STANDBY to LOCK.
If you leave your camcorder in the standby mode for 3 minutes while the cassette
is inserted
Your camcorder automatically turns off. This is to save battery power and to prevent
battery and tape wear. To resume the standby mode, turn STANDBY down and up
again. To start recording, press START/STOP.
13