Sony SPP-AQ600 - Manual (Page 46)

Troubleshooting (continued)
Symptom Remedy
Message is not recorded.
(“F" is flashing in the
message counter.)
10
E
D)
C
a;
g
V)
C
<
The remaining recording time is less than one
minute or 40 messages were recorded. The
answering machine becomes “Annoucement only”
mode and does not record messages. Erase
messages (page 30).
No sound from the speaker
of the base phone.
Adjust the volume (page 15).
The caller's message is
interrupted.
The caller's message is too long.
The caller's voice is too low. The unit disconnects
the line when it detects seven seconds of silence.
The line is disconnected when ■
you call your phone from a
touch-tone phone.
You entered wrong security codes three times.
The clock is incorrect. There was a power interruption. Reset the time
(page 24).
You can't pick up the new
messane.
Record your transfer message or this phone just
dials the destination number (for pager usage).
c
ns
The control code is not
accepted.
Do not elapse 2 seconds between each digit of
control code.
If the trouble persists, please enter (D and your
security code again.
l/l
.Si
Cf
+->
The CHARGE lamp doesn’t
light up when you place the
handset on the base phone.
• Clean the charge contact on the base phone and the
handset with a dry, soft cloth.
fU
iA
(V
u
3
o
«/)
The battery pack has a
shorter life.
• The power wasn't continuously supplied to the base
phone during charging.
• The battery pack was charged less than 12 hours
(due to power failure, etc.).
Cl
>
"E" lights up in the message • Disconnect the AC power cord and connect again.
>
o
a.
counter If the trouble persists, consult your authorized Sony
dealer.
46'
Additional Information