Sony SPP-AQ600 - Manual (Page 42)

Resetting the digital security
code
Since a random security code is automatically assigned between the
base phone and the handset w hen you charge the battery pack for the
first time, you normally do not need to reset the security code.
However, in the unlikely event that you suspect that another cordless
phone uses the same security code, you can manually change the
code as follows:
RING ON/
( intercom )
1
Replace the handset on the base phone.
2
Press ( intercom ).
3
Lift the handset for more than one second.
Then replace the handset on the base phone
and keep it for more than three seconds to
complete the code change.
Notes
• M;ike sure that the RING ON/BATT .SAVE
switch is set to RING ON.
• If the battery pack in the handsel is
completely discharged, or is removed from
the handsel for more than several seconds,
the digital security code stored will be lost.
If this happens, charge the battery pack,
and a new security code will be
auiomalically assigned.
Tip
This procedure will change the code in both
the base phone and the handset. The code can
be chaiiiied as often as desired.
42™ Additional Information