Recording a transfer message, To change the transfer message – Sony SPP-AQ600 User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Transferring a message (continued)
Recording a transfer message
When you w ant to inform the person who answers on the registered
phone number that an incoming message is transferred, record the
transfer message.
1
2
3
Press
C
FLASH/REMOTE ).
The REMOTE lamp lights up.
Press TRANS/CS).
Speak into the hands€^t to record
your transfer mes^e.
You can record up to one minute.
To stop recording, press STOP/CS).
A long confirmation beep sounds,
and your transfer message will be
played back.
Press C FLASH/REMOTE ).
The REMOTE lamp goes off.
Notes
• Make
Mire
ihat RING ON/BATT SAVE switch is set to RING ON.
• If the transfer message is shorter than two seconds, five short error beeps sound
and the transfer message is not recorded.
• There i^ no prerecorded message.
Tip
To record the transfer message from a touch-tone phone, see page 36.
To change the transfer message
Do in the same way as described above. The new transfer message
replaces the old one.
38f
Using as a telephone answering machine