Tomei Powered FINAL GEAR KIT FOR HA PRO KIT - Manual (Page 7)

7
KIT CONTENTS
The kit contents are as follows below.
REQUIRED TOOLS
・Nissan workshop manual ・Screw Lock Paste
・Engine Servicing Tools ・Red Lead Primer ・Bearing Puller
・Torque Wrench ・Liquid Gasket/Silicon ・Oil Seal Drift (SST)
・Dail Gauge ・Flange Wrench
・Preload Gauge
・Pinion Lock Nut （43262-01P1A)×1
・Pinion Seal （38189-P0117)×1
・Side Seal （38342-P9010)×2
・Drive Gear Bolt （38102-7S000)×10
CAUTION
■ This manual is only to be used as a supplement reference guide only. This manual does not provide the complete
installation procedure. For detailed instructions on the procedure, please refer to the official Nissan workshop
service manual.
■ These products are designed to be used for off road competition purposes only.
■ This product is to be installed by a qualified professional in a fully equipped workshop.
■ This product was designed specifically for the application specified.
■ If the attempt was made to use this product on another engine/car other than specified then you will risk damag
this kit and or the engine or components related with it.
■ Do not use any excessive force when using this product as you risk damaging the product or other parts.
■ This product is to be installed with the appropriate tools and equipment to prevent any engine failures and
injuries or bodily harm.
WARNING
■ Install the product only when the engine & drive train is cold.
■ Due to the nature of the area where the product's) is installed. Please exercise caution to prevent any
possible fire hazards from oil etc.
Drive Pinion（1） Drive Gear（1） Collapsible Spacer（1）