Tomei Powered TITANIUM MID Y PIPE - Manual (Page 7)

CAUTION
· Please check all clearances with the vehicles body and make sure that the bolts are not interfering
with anything else. The clearances can vary with each vehicle. So you may need to loosen the bolts
on both the catalytic converter side and the front pipe side, so you can adjust the exhaust, to have
the right clearance with the cars body.
· After fitting the MID Y PIPE please check that there are no signs of oil, dirt so as not to burn them
later when the car is running.
·After fitting the exhaust assembly, check all surrounding areas to be sure that nothing will be at risk from
the heat from the exhaust. You may need to apply extra heat protection to other areas which may be at risk.
5. Reconnect the cars battery negative terminal.
3. INSTALLATION VERIFICATION
1. Check again the vehicle that there are no parts interfering with any other components.
2. Start the engine and let it idle first before taking it up to 2500 RPM to check and listen for any signs of
exhaust leaks or any abnormal sounds. Then recheck the car again for any loose parts or gas leaks.
3. After the initial test drive check the car again for any signs of exhaust gas leakage and any loose parts,
bolts and nuts.
WARNING
· Any interference with any parts/components can pose a fire risk hazard so please meticulously
check the car after the install.
· Any exhaust leaks can decrease performance efficiency and also pose a health risk hazard with
7
· Any exhaust leaks can decrease performance efficiency and also pose a health risk hazard with
toxic exhaust gas poisoning.
· If there is anything felt abnormal when driving please stop immediately and check the car over.
· When any work or checks are to be done with the metal exhaust components then please do so
when it is cold to prevent any burns and injuries.
· If any parts are lost or have fallen off then does not restart the car until the missing parts) can be
replaced properly.
CAUTION
・The vehicles characteristics may change after installing this product so after the install you may need
to have the ECU map settings checked and adjust accordingly to suit the new setup.
7