Tomei Powered TITANIUM MID Y PIPE - Manual (Page 6)

1. REMOVAL OF THE STOCK STANDARD FRONT PIPE
This manual only provides basic instructions. For more details please refer to the vehicles
official factory service manual.
1. Disconnect the car battery's negative terminal.
2. Remove the front pipe.
2. INSTALLATION OF THE TOMEI TITANIUM MID Y PIPE
【Illustration of the mounting position of each bolt & gasket】
The installation of the supplied parts, are as shown below.
① FRONT PIPE R
② FRONT PIPE L
③ COLLECTOR PIPE
④ GASKET Φ60
⑤ FLANGE NUT M10 【34.0∼39.0N・m (3.5∼4.0kgf-m)】
＜Kit contents torque specs＞
①
②
③
④
⑤※
⑥
⑧
⑤※
⑥
⑦
⑤※
⑤※
⑨※
⑨※
⑩
6
⑤ FLANGE NUT M10 【34.0∼39.0N・m (3.5∼4.0kgf-m)】
⑥ CLAMP BAMD【16.0N・m (1.63kgf-m)】
⑦ COPPER WASHER
⑧ BLIND PLUG
⑨ FLANGE BOLT M10【34.0∼39.0N・m (3.5∼4.0kgf-m)】
⑩ GASKET Φ80
※Apply the Bolt Smooth Paste (included) to the parts which will be exposed to high temperatures.
This helps reduce the parts from sticking and seizures.
【Installation Procedure】
1. Fit the Left & Right pipes to the collector pipe, with the clamp bands (loose, don't tighten them yet).
Then fit the assembly into position, on the car. Check that the "UP" mark on the collector pipe is facing
the vehicles body side.
※ Use the supplied Front Pipe R (as above①), Front Pipe L (as above ②), Collector Pipe (as above③),
Clamp Band (as above⑥).
2. Test fit the front pipe assembly with the catalytic converter and the center muffler.
※ Use the supplied gaskets (as above ④ & ⑩), Falnge Nut (as above⑤), Flange Bolt (as above ⑨).
3. Checking the surrounding for to ensure that there is no interference with the setup and the surrounding parts.
Adjust then tighten the bolts from the front to the back.
Torque Specs Flange Nuts & Bolts M10 (as above ⑤, ⑨)【34∼39N・m (3.5∼4.0kgf-m)】
4. Check the surrounding areas for interference, and then tighten the clamp bands on the collector pipe.
Torque Specs Clamp Bands ( shown above ⑥) 【16 N・m (1.63 kgf-m)】
④
⑤※
6