Tomei Powered TITANIUM MUFFLER - Manual (Page 6)

1. REMOVAL OF THE STOCK STANDARD EXHAUST MUFFLER
This manual only provides the simple instructions. For more details please refer to the vehicles
official service manual.
1. Disconnect the cars negative terminal battery.
2. Remove the exhaust main muffler.
3. Remove the center exhaust pipe.
4. Remove the exhaust muffler cover (rubber) from the car bodys left side.
2．INSTALLATION OF THE TOMEI TITANIUM MUFFLER
【Illustration of the mounting position of each bolt & gasket】
The installation of the bolts included in the kit is shown below.
【MOUNTING INSTRUCTIONS】
1. Use the main pipe gasket with the flange M12 bolts with a trail fitting on the main pipe prior to final
fitment.
* Use the included gasket (above ④) & bolt M12 (above ⑤).
2. Use the clamp band on the main pipe with the horizontal spring hooks on both sides of the pipe. This
will give the best support with the installation with the muffler hanger.
* Use the included clamp band (above⑦).
3. Use the clamp band with the horizontal spring hooks on the silencer ASSY with the main pipe.
* Use the included clamp band (above⑦).
The mufflers Tomei Logo is to be installed facing down to the ground.
6
①
②
③
⑥
④
⑥
⑥
⑥
⑤
⑤
⑦
⑦ ⑧
⑨
⑩
⑪
⑫
⑬※
① Main Pipe A
② Main Pipe B
③ Silencer ASSY
④ Gasket
⑤ Flange Bolt M12 ［56.0~94.0 N・m (5.7~9.6kgf-m)］
⑥ Springs
⑦ Clamp Band [25.0N・m(2.6kgm-f)]
⑧ Silencer Band
⑨ Silencer Band Rubber
⑩ Flange Bolt M8
⑪ Flange Nut M8 [20.0~28.0N・m (2.0~2.9kgm-f)]
⑫ Sound Reducer
⑬ Button Bolt M6 [8.0~12.0N・m (0.8~1.2kgm-f)]
* Apply the bolt smooth paste that is supplied in
the kit to prevent metal burns and seizures to
the bolts and nuts.