Tomei Powered H-BEAM CONNECTING RODS - Manual (Page 8)

KIT CONTENTS
Each kit must have the items as shown below in the quantity as stated.
・Conrods for 4 cylinder engines comes with 4 Conrods as a set.
・Conrods for 6 cylinder engines comes with 6 Conrods as a set.
REQUIRED TOOLS
These tools are the bare minimum required for the job.
・General Engine Maintenance Tools ・Precision Instruments ・Conrod Bearings
※7/16 12 Point Socket Required such as micrometers
・Beam Type Torque Wrench ・Workshop Service Manual
With indicators.
CAUTION
■ These products are designed to be used for off road competition purposes only.
CONROD BOLT
CONROD CAP
CONROD
MOLYBDENUM GREASE (1)
8
■ This product is NOT for use on public roads, due to safety risks. This product may not be road legal in your
area.
■ This product is to be installed by a qualified professional in a fully equipped workshop.
■ If the attempt was made to use this product on another engine/car other than specified then you will risk
damaging this kit and or the engine or components related with it.
■ The conrod bolts must be tightened with the correct torque settings. If not done correctly, you will run the risk
of possible terminal engine failure.
■ Please periodically inspect the tightened sections.
■ Do not use any excessive force when using this product as you risk damaging the product or other parts.
■ This product is to be installed with the appropriate tools and equipment to prevent any engine failures and
injuries or bodily harm.
■ The other assembly instructions and torque settings that is not mentioned in this manual. Those can be
found from the official service manual of that brand of the engine that you have.
■ Please be sure to set the correct torque settings within the allowed tolerances that has been indicated on this
manual. Failure to do so can lead to unwanted vibrations which can then cause trouble with possible engine
failure.
■ Please do take care not to damage these items whilst handling and during the assembly process. If the product
has been dropped or mishandled, this can cause the product/item to be weaker. The stress factors may risk
a possible future engine failure.
■ When there is another installation manual that is supplied with other related components (such as the Piston
kit), please refer to both manuals during the assembly process.
8