Tomei Powered H-BEAM CONNECTING RODS - Manual (Page 11)

6. PISTON, CONROD INSTALLATION
① Apply oil to the cylinder wall surface, the outer
part of the pistons and the connecting rods
bearings surface.
② Check the pistons position prior to installation.
③ Verify the front marking of the pistons, then install
the piston and rods with a piston ring compressor.
④ Verify the sequence number of the connecting rod
and the connecting rod caps before attaching the caps.
⑤ Tighten the connecting rod bolts to the stipulated
torque settings.
※NOTE: The permitted bolt stretch limits for the
above is 0.12～0.15mm
Torque 15N・m （1.5kgm）
2nd Angle Wrench 60～65°
1st
11
Be sure to tighten the bolts with a Torque
Angle Wrench.
11