ClearSounds PHONE A1600 - Manual (Page 19)

19 – ENGLISH
Installing Batteries
Three AAA re-chargeable Ni-MH batteries come with your
phone. You must install the handset batteries before using
your phone.
1. Remove the battery compartment
cover by sliding it downwards.
2. Insert the new batteries. Be
sure to observe battery polarity
as imprinted on the inside of
the compartment.
3. Replace the battery compartment
cover by sliding upward until it
clicks into place
Note : The batteries need to be replaced if they do not recover
their full storage capacity after recharging. Check the battery
icon on the LCD to see the battery charge level.
When replacing the batteries, always use good quality Ni-MH
AAA re-chargeable batteries.
Charging the Handset
1. Place the handset into the base. The LCD
screen will light up and you will hear a
beep to indicate charging has begun.
2. Important: Before initial operation,
you should fully charge the handset
for at least 15 hours.
3. After the batteries are fully charged, check for dial tone by
pressing the dial key on the handset.
When battery power is very low and you place the handset on
the base, the display will show . Check the
battery icon on the LCD to see the battery charge level.