beautypg.com

Opening the computer cover – Dell Dimension 4300 User Manual

Page 65

background image

Adding Parts

65

FILE LOCATION:

FILE LOCATION:

FILE LOCATION:

FILE LOCATION: C:\Projects\Green_Lantern_solutions\2H930c31.fm

D E L L C O N F I D E N T I A L – P R E L I M I N A RY 1 1 / 2 0 / 0 1

D E L L C O N F I D E N T I A L – P R E L I M I N A RY 1 1 / 2 0 / 0 1

D E L L C O N F I D E N T I A L – P R E L I M I N A RY 1 1 / 2 0 / 0 1

D E L L C O N F I D E N T I A L – P R E L I M I N A RY 1 1 / 2 0 / 0 1

8

After the hinge arms clip into place, lower and raise the arms two or

three times to properly seat them.

9

Reattach the front-panel insert.

10

Reconnect the power cable to your computer.

11

Reattach the front door as described on page 62.

Opening the Computer Cover

CAUTION:

Before you begin any of the procedures in this section,

follow the safety instructions listed in “When Working Inside

Your Computer” on page 12.

1

Shut down the computer (see page 20).

2

Turn off any attached devices and disconnect them from their

electrical outlets.

NOTICE:

To disconnect a network cable, first unplug the cable from your

computer and then unplug it from the network wall jack.

3

Disconnect the computer power cable from the wall outlet, and then

press the power button to ground the system board.

NOTICE:

Ensure that there is sufficient space to support the open cover—at

least 30 cm (1 ft) of desk top space.

4

Lay the computer on its side so that the arrow on the bottom of the

computer points up.Located the two release buttons shown in the

illustrations. Then, press the two release buttons as you lift the cover.

2H930bk1.book Page 65 Tuesday, November 20, 2001 5:02 PM