Dell PowerEdge SC1430 - Manual (Page 87)

Installing System Components
87
Figure 3-28. Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1 Align the chassis intrusion switch with the securing bracket notch. See Figure 3-28.
2 Slide the switch into the securing bracket notch.
3 Connect the switch cable to the INTRUDER connector on the system board.
4 Close the system. See "Closing the System" on page 43.
5 Reconnect the system to the electrical outlet, and turn on the system.
Removing and Replacing the Bezel (Service Only Parts Procedure)
Removing the Bezel
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for complete
information about safety precautions, working inside the computer and protecting against electrostatic discharge.
1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 43.
1 chassis intrusion switch 2 securing bracket notch 3 INTRUDER connector
1
2
3
book.book Page 87 Monday, June 5, 2006 1:51 PM