Dell PowerVault 110T LTO2 (Tape Drive) - Manual (Page 19)

Power requirements
Performance
l interface: Ultra160 LVD SCSI
l recording format: LTO Ultrium Generation 2
l media: LTO Ultrium
l capacity: 200 GB (native) 400 GB (compressed, assuming 2:1 compression)
l sustained transfer rate: native 35 MB/sec, compressed 70 MB/sec (assumes 2:1 compression)
l burst transfer rate: up to 160 MB/sec
Operating limits
l temperature: 10 degrees C to 35 degrees C (50 degrees F to 95 degrees F)
l humidity: 20% to 80% Relative Humidity (non-condensing)
l maximum wet bulb temperature: 29 degrees C (84.2 degrees F)
l maximum altitude: 3048 m (10,000 ft)
Non-operating limits (Storage)
l temperature: -40 degrees C to 65 degrees C (-40 degrees F to 149 degrees F)
l humidity: 5% to 95% Relative Humidity (non-condensing)
l maximum wet bulb temperature: 38 degrees C (100 degrees F)
Back to Contents Page
Tolerance + 5 Vdc and + 12 Vdc (plus or minus 10%)
Power supply current for 5 Vdc 1.3 A minimum/3.1 A maximum
Power supply current for 12 Vdc 0.2 A minimum/1.1 A maximum
Power supply peak for 5 Vdc (the instantaneous power by the power supply) 3.3 A for 100 ms15.5 W
Power supply peak for 12 Vdc (the instantaneous power by the power supply) 4.1 A for 2 ms49.2 W
Power usage for typical idle mode with no cartridge 10.9 W
Power usage for typical idle mode with a cartridge loaded 12.7 W
Power usage for reading and writing at 6.22 m/s 29 W
Power usage for sleep mode with no cartridge 9.0 W
Power usage for sleep mode with a cartridge loaded 10.8 W