Dell Inspiron 9300 - Manual (Page 98)

98
Adding and Replacing Parts
www
.dell.com | support.dell.com
4 Insert a scribe into the notch and push it to the side to release the drive from the bay.
5 Slide the drive out of the bay.
To reinstall the optical drive, slide the drive into the drive bay and snap it into place. Then replace
the optical-drive security screw.
Internal Card With Bluetooth
®
Wireless Technology
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on the back of the computer).
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin
working inside the computer.
If you ordered a card with Bluetooth wireless technology with your computer, it is already installed.
1 Follow the procedures in "Before You Begin" on page 81.
2 Remove the battery. See page 31.
3 Loosen the captive screw and remove the card cover from the computer.
optical-drive security screw
optical drive
notch