Dell Dimension 5150C - Manual (Page 65)

System SetupDell Dimension 5150C Service Manual
file:///T|/htdocs/systems/dim5150C/en/sm/syssetup.htm[10/31/2012 8:21:30 AM]
4. Reset the current CMOS settings:
a. Locate the 3-pin CMOS jumper (RTCRST) on the system board .
b. Remove the jumper plug from pins 2 and 3.
c. Place the jumper plug on pins 1 and 2 and wait approximately 5 seconds.
d. Replace the jumper plug on pins 2 and 3.
5. Replace the hard drive .
6. Replace the computer cover .
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
7. Connect your computer and devices to electrical outlets, and turn them on.