Modem – Dell Dimension 5150C User Manual
Page 30

Removing and Installing Parts: Dell Dimension 5150C Service Manual
file:///T|/htdocs/systems/dim5150C/en/sm/parts1.htm[10/31/2012 8:21:07 AM]
NOTICE:
Socket pins are delicate. To avoid damage, ensure that the processor is aligned properly with the socket, and
do not use excessive force when you install the process. Be careful not to touch or bend the pins on the system board.
4. Set the processor lightly in the socket and ensure that the processor is level in the socket. When the processor is
positioned correctly, press it with minimal pressure to seat it.
5. When the processor is fully seated in the socket, close the processor cover.
6. Pivot the socket release lever back toward the socket and snap it into place to secure the processor.
NOTICE:
When you install the heat-sink assembly, do not touch the thermal interface to prevent damage to the
thermal interface material on the interface.
NOTICE:
If you are not installing a processor upgrade kit from Dell, reuse the original heat-sink assembly when you
replace the processor.
If you installed a processor replacement kit from Dell, return the original heat-sink assembly and processor to Dell in
the same package in which your replacement kit was sent.
if you removed it.
8. Plug the fan cable into the FAN connector on the
9. Install the
10. Plug the power cable into the 12VPOWER connector on the
.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
12. Connect your computer and devices to electrical outlets, and turn them on.
Modem