Dell Alienware 15 (Early 2015) - Manual (Page 59)

Replacing the power-button
board
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in Before working inside your computer .
After working inside your computer, follow the instructions
in After working inside your computer . For more safety best
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the power-button board with the screw holes on
the palm-rest assembly.
2 Replace the screws that secure the power-button board to the palm-rest
assembly.
3 Slide the touch-pad cable and status-light cable into the power-button
board and press down on the latches to secure the cables.
4 Connect the power-button board cable to the power-button board.
Post-requisites
1 Follow the procedure from step 5 to step 11 in “Replacing the palm rest ”.
2 Replace the solid-state drives .
3 Replace the memory modules .
4 Replace the base panel .
59