Baseboard management controller configuration, Entering the bmc setup module – Dell PowerEdge T110 User Manual
Page 54
54
Using the System Setup Program and UEFI Boot Manager
Baseboard Management Controller Configuration
The BMC enables configuring, monitoring, and recovery of systems remotely.
BMC provides the following features:
•
Enables fault logging and SNMP alerting
•
Provides access to system event log and sensor status
•
Allows control of system functions including power on and off
•
Functions independently of the system’s power state or the system’s
operating system
•
Provides text console redirection for system setup, text-based utilities, and
operating system consoles
NOTE:
To remotely access the BMC through the integrated NIC, you must connect
the network connection to integrated NIC1.
For additional information on using BMC, see the documentation for the
BMC and systems management applications.
Entering the BMC Setup Module
1 Turn on or restart your system.
2 Press
If your operating system begins to load before you press
allow the system to finish booting, and then restart your system and try
again.
Mayzie_HOM.book Page 54 Monday, August 31, 2009 9:33 PM