Dell PowerEdge T110 - Manual (Page 24)

24
About Your System
Local keyboard
may not work
because all user
accessible USB
ports are
disabled. If
operating
locally, power
cycle the system
and enter system
setup program to
change settings.
The USB ports are disabled
in the system BIOS. Power down and restart the
system from the power button,
and then enter the System
Setup program to enable the
USB port(s). See "Entering the
System Setup Program" on
page 36.
Manufacturing
mode detected.
System is in manufacturing
mode. Reboot to take the system out
of manufacturing mode.
Maximum rank
count exceeded.
The following
DIMM has been
disabled: x
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled. Ensure that the memory
modules are installed in a valid
configuration. See "General
Memory Module Installation
Guidelines" on page 80.
Memory address
line failure at
address , read
value expecting
value.
Faulty or improperly
installed memory modules. See "Troubleshooting System
Memory" on page 113.
Memory double
word logic
failure at
address , read
value expecting
value.
Faulty or improperly
installed memory modules. See "Troubleshooting System
Memory" on page 113.
Memory
Initialization
Warning: Memory
size may be
reduced.
Invalid memory
configuration. The system
will run but with less
memory than is physically
available. Ensure that the memory
modules are installed in a valid
configuration. See "General
Memory Module Installation
Guidelines" on page 80.
Message Causes Corrective Actions
Mayzie_HOM.book Page 24 Monday, August 31, 2009 9:33 PM