Dell PowerEdge C6100 - Manual (Page 54)

54 Using the Baseboard Management Controller
Table 1-58. Configuration ID = 11h, Power Management
Attribute ID Size e Description
Power 1
Management
Enable 1 Specify the use of power management method.
Bit 7: Enable DPNM power management
1b = enable DPNM
0b = disable DPNM
Bit 6:0: reserved
Power 2
Staggering AC
Recovery
1 This parameter is only effective if the Power Policy is
not set to always off.
0x00 : Immediate PowerOn (No Delay) : Default
0x01 : Auto (Random), the auto generated delay time
must be in the range of Minimum Power On Delay
and Maximum Power On Delay.
0x02 : User Defined, the user defined delay time
must be in the range of Minimum Power On Delay
and Maximum Power On Delay.
Power On Delay 3 2 Define the time to delay power on the system after AC
recovered.
Minimum 4
Power On Delay 2 Specify the minimum power on delay time when AC
is restored. This should not be less than the time
BMC startup time.
Maximum 5
Power On Delay 2 Specify the maximum power on delay time when AC
is restored. The number must large than Minimum
Power On Delay.