Dell PowerEdge C6100 - Manual (Page 27)

27 Using the Baseboard Management Controller
Table 1-27. Firmware Commands (NETFUN: 08H, 09H)
Commands NetFn CMD Request and Response
Get Update Status Firmware 02H REQUEST
Byte 1 — Task ID
RESPONSE
Byte 1 — Completion Code
Byte 2 — Status
• 00H: Transmitting
Image
• 01H: Validating Image
• 02H:
Programming
• 03H: Ready to Accept
Image
• 80H: General
error
• 81H: Cannot establish
connection
• 82H: Path not found
• 83H: Transmission
Abort
• 84H: Checksum error
• 85H: Incorrect
Platform
• FFH: Completed
Byte 3 — Progression Indicator. This field is optional. If
present, its value indicates the current progress of the status
specified in Status byte.
Copy Image Data Firmware 03H REQUEST:
Byte 1 — Task ID
Byte 2 — In
progress
00H = Data transmission is in
progress
01H
= Data transmission
completed Byte 3:6 — Image offset
to be copied Byte 7:N — Image data
to be copied RESPONSE:
Byte 1 — Completion Code