Dell PowerEdge C6100 - Manual (Page 50)

50 Using the Baseboard Management Controller
Extended Configurations
Table 1-50. Configuration ID = 02h, NIC
Attribute ID Size Description
NicSelection 1 1 Specifies the current mode of operation for the BMC
network interface.
0: Shared NIC (default)
1: Dedicated NIC
Table 1-51. Configuration ID = 03h, SOL
Attribute ID Size Description
SOL Idle Timeout 1 2 byte1:2 - Define the inactivity timeout in minutes, 1-
based, LSByte first. This parameter only applies to the
IPMI over LAN session with SOL payload activated.
0h= session does not timeout and close due to inactivity.
Default = 01h
Telnet/SSH 2
Redirect
Enable 1 0: Disabled (default)
1: Enabled
Table 1-52. Configuration ID = 04h, Security
Attribute ID Size Description
Service Disabled 1 1 Disable or enable services. This attribute takes
precedence over the individual feature enabled/disabled.
Once one service has been disabled, the BMC must not
allow user to enable the corresponding feature and D5h
completion code must be returned. For example, if
HTTP/HTTPS is disabled, user must not allow to enable
the Web Server through Web Server Configuration
(Configuration ID 0Ch). In other words, Web can only be
disabled or enabled when HTTP/HTTPS is enabled.
[0] - all service except IPMI are disabled. This bit takes
precedence over other bits. Default is 0.
[1] - KVM/Virtual Storage, enabled by default.
[2] - HTTP/HTTPS, enabled by default.
[3] - SSH/Telnet, disabled by default.
Max 2
Authentication
Failures
1 Specifies the maximum number of allowed
authentication failures. Setting this value to 0 will disable
the lockout feature.
When an account Is lockout, the IPMI Messaging must be
disabled on the LAN channel. See Get User Access
command.
Default = 00h (disable Lockout feature)