Dell POWEREDGE 1950 - Manual (Page 74)

74 Installing System Components
Figure 3-17. Removing and Installing the Optical Drive Tray
Installing the Optical Drive Tray
1 Align the optical drive tray with its opening in the front panel.
The optical drive opening is located directly below the SAS daughter card bay.
2 Slide in the drive tray until the tray snaps into place. See Figure 3-17.
3 Connect the optical-drive cable from the back of the drive. See Figure 3-17.
4 Replace the SAS controller daughter card.See "Installing a SAS Controller Daughter Card or SAS RAID
Controller Daughter Card" on page 56.
5 Close the system. See "Opening and Closing the System" on page 46.
6 Replace the bezel. See "Removing and Replacing the Front Bezel" on page 45.
7 Reconnect your system and peripherals to their electrical outlets, and turn on the system.
1 optical -drive tray 2 optical-drive cable 3 optical-drive release tab
4 optical drive
3
2 1
4