Wireless network setup – Dell B1163/W Multifunction Mono Laser Printer User Manual

Page 112

Wireless network setup

112

2. Using a Network-Connected Machine

Machines without a display screen

Connecting in PBC mode

Press and hold the

(WPS) button on the control panel for about 2 - 4

seconds until the status LED blinks quickly.

The machine starts connecting to the wireless network. The LED blinks
slowly for up to two minutes until you press the PBC button on the
access point (or wireless router).

Press the WPS (PBC) button on the access point (or wireless router).

a The light blinks fast on the WPS LED. The machine is connecting to

the access point (or wireless router).

b When the machine is successfully connected to the wireless

network, the WPS LED light stays on.

Insert the supplied CD into the CD/DVD drive and proceed to install the
software following the directions on the screen. When the "Connect
Printer" screen appears, select the Network (Ethernet/Wireless)
connection.

Connecting in PIN mode

The network configuration report, including PIN, must be printed.

In ready mode, press and hold the

(Cancel or Stop/Clear) button on

the control panel for about 5 seconds. You can find your machine’s PIN.

Press and hold the

(WPS) button on the control panel for more than

4 seconds until the status LED stays on.

The machine starts connecting to the access point (or wireless router).

You need to enter the eight-digit PIN within two minutes on the
computer that is connected to the access point (or wireless router).

The LED blinks slowly for up to two minutes until you enter the eight-
digit PIN.

The WPS LED blinks in the order below:

a The light blinks fast on the WPS LED. The machine is connecting to

the access point (or wireless router).

b When the machine is successfully connected to the wireless

network, the WPS LED light stays on.