Canon B160 - Manual (Page 18)

1-7
Making connections
1
SETTING UP
Connecting the AC power cord ________________
Plug the fax into a 200-240 volt AC 50/60 Hz outlet.
When you plug in the fax for the first time, you need to select the correct language for the LCD display and
reports, and the country* of use.
K K Setting the language and country
1 Plug the power cord connector into the
rear of the fax. 2 Plug the other end of the power cord into
a properly grounded AC power outlet.
1
Plug in the fax.
After a few seconds, the LCD changes to this display.
2
Use [ u ] or [ d ] to select the preferred language for
the LCD display and reports.
Press [Set].
Wait a second for COUNTRY SELECT*
to appear.
Press [Set].
3
Use [ u ] or [ d ] to select the country where you are
using the fax*.
Press [Set].
Registration ends and the fax enters standby mode.
PLEASE WAIT
u ENGLISH d
u ENGLISH d
Set DATA ENTRY OK
1 sec.
COUNTRY SELECT
UK
Set
UK
Set
DATA ENTRY OK
There is no power switch on the fax. The
power is on as long as the fax is plugged in.
* This setting is only available for some countries.