Dell PowerEdge R300 - Manual (Page 40)

40
About Your System
Plug & Play
Configuration Error
Error encountered in
initializing PCIe device;
faulty system board. Install the NVRAM_CLR
jumper and reboot the
system. See Figure 6-1 for
jumper location. If the
problem persists, see
"Troubleshooting Expansion
Cards" on page 149.
Read fault
Requested sector
not found
The operating system
cannot read from the hard
drive or USB device, the
system could not find a
particular sector on the
disk, or the requested
sector is defective. Replace the USB medium or
device. Ensure that the USB
or hard drive cables are
properly connected. See
"Troubleshooting a USB
Device" on page 129,
"Troubleshooting an Internal
USB Key" on page 139, and
"Troubleshooting a Hard
Drive" on page 144.
Remote
configuration
update attempt
failed
System unable to process
Remote Configuration
request. Retry Remote Configuration.
ROM bad checksum =
address
Expansion card
improperly installed or
faulty. Reseat the expansion card(s).
Ensure that all appropriate
cables are securely connected
to the expansion card(s). If
the problem persists, see
"Troubleshooting Expansion
Cards" on page 149.
SATA PORT x drive
not found
SATA port x was turned
on in setup, but a drive
was not found. See "Troubleshooting a Hard
Drive" on page 144 for the
appropriate drive(s) installed
in your system.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
book.book Page 40 Sunday, June 21, 2009 5:16 PM