Dell PowerEdge R310 - Manual (Page 68)

68
Using the System Setup Program and UEFI Boot Manager
Using the System Password
When a system password is assigned, the system prompts for the system
password after the system starts and only those with the password have full
access to the system.
Assigning a System Password
Before assigning a system password, enter the System Setup program and
check the System Password option.
When a system password is assigned, System Password is Enabled. If
Password Status is Unlocked, you can change the system password. If Locked,
you cannot change the system password. Disabling the password jumper on
the system board sets System Password to Disabled, and you cannot change
or enter a new system password.
When a system password is not assigned and the password jumper on the
system board is in the enabled position, System Password is Not Enabled and
Password Status is Unlocked.
To assign a system password:
1 Verify that Password Status is Unlocked.
2 Highlight the System Password option and press .
3 Type your new system password.
You can use up to 32 characters in your password.
As you type, placeholders appear in the field.
The password assignment is not case-sensitive. Certain key combinations
are invalid and if you enter one, the system beeps. To erase a character,
press or the left-arrow key.
NOTE:
To escape from the field without assigning a system password, press
to move to another field, or press prior to completing step 5.
4 Press .
R310HOM.book Page 68 Thursday, March 4, 2010 1:03 AM