Dell Dimension 5150/E510 - Manual (Page 78)

78
Removing and Installing Parts
8 Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
9 If you replaced a card that was already installed in the computer and you removed the retention
mechanism, you may reinstall the retention mechanism.
10 Before replacing the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
11 Snap the card retention mechanism into place, securing the x16 PCI card.
fully seated
card
not fully seated
card
bracket caught
outside of slot
bracket within slot
alignment guide
alignment bar
card retention
door
release tabs (2)
card retention
mechanism
WD846bk2.book Page 78 Thursday, September 14, 2006 2:40 PM