Dell Dimension 5150/E510 User Manual
Page 114
114
Appendix
Changing Boot Sequence for the Current Boot
You can use this feature, for example, to restart your computer to a USB device such as a floppy drive,
memory key, or CD-RW drive.
NOTE:
If you are booting to a USB floppy drive, you must first set the floppy drive to OFF in system setup (see
1 If you are booting to a USB device, connect the USB device to a USB connector (see "Connectors" on
2 Turn on (or restart) your computer.
3 When
F2 = Setup, F12 = Boot Menu
appears in the upper-right corner of the screen,
press
If you wait too long and the operating system logo appears, continue to wait until you see the
Microsoft Windows desktop. Then shut down your computer (see "Turning Off Your Computer" on
page 59) and try again.
The Boot Device Menu appears, listing all available boot devices. Each device has a number next to it.
4 At the bottom of the menu, enter the number of the device that is to be used for the current boot only.
For example, if you are booting to a USB memory key, highlight
USB Flash Device and press
NOTE:
To boot to a USB device, the device must be bootable. To make sure your device is bootable, check the
device documentation.
Changing Boot Sequence for Future Boots
1 Enter system setup (see "Entering System Setup" on page 108).
2 Use the arrow keys to highlight the Boot Sequence menu option and press
NOTE:
Write down your current boot sequence in case you want to restore it.
3 Press the up- and down-arrow keys to move through the list of devices.
4 Press the spacebar to enable or disable a device (enabled devices have a checkmark).
5 Press plus (+) or minus (–) to move a selected device up or down the list.
WD846bk2.book Page 114 Thursday, September 14, 2006 2:40 PM