beautypg.com

Addressing memory with 4-gb configurations, Installing memory – Dell Dimension 5150/E510 User Manual

Page 69

background image

Removing and Installing Parts

69

NOTE:

Memory purchased from Dell is covered under your computer warranty.

NOTICE:

If you remove your original memory modules from the computer during a memory upgrade, keep them

separate from any new modules that you may have, even if you purchased the new modules from Dell. If possible,
do not

pair an original memory module with a new memory module. Otherwise, your computer may not start

properly. You should install your original memory modules in pairs either in DIMM connectors 1 and 2 or DIMM
connectors 3 and 4.

Addressing Memory With 4-GB Configurations

Your computer supports a maximum of 4 GB of memory when you use four 1-GB DIMMs. Current
operating systems, such as Microsoft

®

Windows

®

XP, can only use a maximum of 4 GB of address space;

however, the amount of memory available to the operating system is less than 4 GB. Certain components
within the computer require address space in the 4-GB range. Any address space reserved for these
components cannot be used by computer memory.

Installing Memory

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions in the

Product Information Guide.

NOTICE:

To prevent static damage to components inside your computer, discharge static electricity from your

body before you touch any of your computer’s electronic components. You can do so by touching an unpainted
metal surface on the computer chassis.

1 Follow the procedures in "Before You Begin" on page 59.
2 Lay the computer on its side so that the system board is on the bottom of the inside of the computer.

Channel A: matched pair of memory
modules in connectors DIMM_1
and DIMM_2 (white securing clips)

Channel B: matched pair of memory
modules in connectors DIMM_3
and DIMM_4 (black securing clips)

WD846bk2.book Page 69 Thursday, September 14, 2006 2:40 PM