Dell Precision 390 User Manual
Page 76

Removing the Drive Panel (Tower Computer)
1.
.
2.
Remove the computer cover (see
).
3.
Remove the front panel. See
.
4.
Grasping the lever on the sliding plate, pull the sliding plate to the right until it releases the drive panel from its side hinges.
5.
Set the drive panel aside in a secure location.
Removing a Drive-Panel Insert
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer.
NOTE:
If you have a desktop computer, the drives and drive panel will appear differently.
1
sliding plate
2
sliding-plate lever
3
drive panel
NOTE:
This sliding plate secures and releases the drive panel and helps to secure the drives.
NOTICE:
Drive-panel inserts may contain screws on the inside. You can attach the screws to new drives that do not have any screws.
1 drive panel
2 drive-panel
insert
3 drive-panel insert release tabs
(2)
4 drive-panel insert tab in tab
slot
NOTICE:
To avoid breaking the drive-panel insert tab, do not pull the insert more than approximately 1 cm (½ inch) away from the drive panel before
sliding the tab out of the slot.