Drives, Tower computer drives – Dell Precision 390 User Manual
Page 63
The computer should have changed the value of System Memory to reflect the newly installed memory. Verify the new total. If it is correct, skip to
9.
If the memory total is incorrect, turn off and disconnect your computer and devices from their electrical outlets, remove the computer cover (see
), and check the installed memory modules to ensure that they are seated properly in their sockets. Then repeat steps 6,
7, and 8.
10.
When the System Memory total is correct, press
11.
Run the Dell Diagnostics (see
Dell Diagnostics
) to verify that the memory modules are operating properly.
Removing Memory
1.
.
2.
Remove the computer cover (see
).
3.
Press out the securing clip at each end of the memory module connector.
4.
Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.
Drives
Tower Computer Drives
Possible fully-populated computer configurations:
l
Four serial ATA (SATA) hard drives, one optical drive, and one floppy drive or one Media Card Reader
l
Three (SAS or SATA) hard drives, one optical drive, and one floppy drive or one Media Card Reader
l
One or two (SAS or SATA) hard drives with up to two optical drives and one floppy drive or one Media Card Reader
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer.
1 upper 5.25-inch drive bay
(holds CD/DVD drive)
2 lower 5.25-inch drive bay
(holds optional CD/DVD
drive or optional fourth
3* additional fan space