Dell PowerEdge C2100 - Manual (Page 89)

Installing System Components 85
4 Secure the RAID battery carrier onto the chassis using the two screws. See
Figure 3-16.
5 Connect the RAID battery cable to the RAID battery connector on the
storage controller card. See Figure 3-15.
6 Close the system. See "Closing the System" on page 59.
7 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
Dual RAID Battery (Optional)
NOTE: The information in this section applies only to systems with the optional
RAID controller card.
Removing a Dual RAID Battery
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 58.
3 Locate the dual RAID battery carrier and remove the two screws that
secure the battery carrier on to the chassis. See Figure 3-17.
4 Disconnect the cable between the RAID battery and the storage controller
card. See Figure 3-16.
5 Slide the dual RAID battery carrier slightly toward the front of the system
and lift it away from the system. See Figure 3-17.
6 Gently push the RAID batteries inside the battery carrier to free them of
the battery carrier. See Figure 3-18.
book.book Page 85 Friday, November 8, 2013 11:29 AM