Dell PowerEdge 2800 - Manual (Page 31)

Tower-to-Rack and Rack-to-Tower Conversion Guide
29
2 Install the tower control panel assembly.
a Using a #2 Phillips screwdriver, remove the screw that secures the I/O board to the rack
carrier.
b Using a #2 Phillips screwdriver, remove the two screws that secure the LCD board to the
rack carrier.
c Align the I/O board on the tower carrier.
d Using a #2 Phillips screwdriver, install the screw that secures the I/O board to the tower
carrier.
e Align the LCD board on the tower carrier.
NOTICE:
The system ID switch plunger is very fragile. When aligning the LCD board on the tower carrier,
be careful not to damage the system ID switch plunger.
f Using a #2 Phillips screwdriver, install the two screws that secure the LCD board to the
tower carrier.
g Remove the protective covering from the rack carrier plastic lens.
h Slide the control panel assembly’s cable through the hole in the drive tray.
i Align the tabs on the control panel assembly with the slots in the drive tray.
j Slide the control panel assembly toward the tower front panel until it stops.
k While holding the control panel assembly in place, install the three screws (that came
with your kit) that secure the control panel assembly to the tower front panel.
3 Inside the drive tray, latch the control panel assembly cable clamp.
4 Connect the control panel assembly cable to the SCSI backplane board.
5 Orient the system as shown in Figure 1-16.
6 Reinstall the hard drives, any optical drives, and devices installed in the media bay in the
system.
NOTE:
Ensure that the hard drives, any optical drives, and devices are reinstalled into the same
positions that they were removed from. The devices should be labeled appropriately.
7 Connect any cables to the devices in the media bay.
8 Slide the drive tray backward and then rotate the drive tray release lever backward until the
drive tray is in the operational position. See Figure 1-16.
9 Tighten the captive screw that secures the drive tray release lever to the drive tray.
10 Install the painted top cover that came with your kit. See Figure 1-15.
Installing the Metal Feet and Bezel
1 Position the system on a flat working surface so that the system is slightly hanging over the
edge. See Figure 1-18.
Y1001bk0.book Page 29 Thursday, July 8, 2004 4:32 PM