Dell PowerEdge 2800 - Manual (Page 12)

10
Tower-to-Rack and Rack-to-Tower Conversion Guide
www
.dell.com | support.dell.com
Figure 1-2. Removing the Tower Bezel
2 Remove the four metal feet from the system:
a Orient the system so that the metal feet hang over the edge of the table as shown in
Figure 1-3.
b Using a #2 Phillips screwdriver or a 1/4-inch nut driver, remove the screw that secures
each metal foot and pull each foot from the chassis. See Figure 1-3.
Repeat this step for the other three metal feet.
bezel
keylock
Y1001bk0.book Page 10 Thursday, July 8, 2004 4:32 PM