Dell PowerVault 211S (SCSI) - Manual (Page 35)

support.dell.com Installing Your Stand-Alone Storage System 3-3
4. Place the top hat flange along the right side of the storage system and align the
screw holes (see Figure 3-2).
)LJXUH ,QVWDOOLQJ WKH +DW )ODQJH
5. Using a Phillips-head screwdriver, attach the hat flange to the chassis with four
6-32 x 1/4-inch flat-head screws as shown in Figure 3-2.
6. Carefully place the storage system on its right side.
The enclosure indicator lights should be at the bottom.
7. Repeat steps 3 through 5 to mount the bottom hat flange on the storage system.
$WWDFKLQJ 6WDELOL]HUV WR WKH 6WDQG$ORQH &KDVVLV
1. Carefully turn the stand-alone chassis upside down.
2. Locate the two pairs of screw holes on the bottom panel.
1 6-32 x 1/4-inch flat-head screws
2 Hat flange