Dell PowerEdge T100 - Manual (Page 24)

24
About Your System
PCIe Training
Error: Slot n
Faulty or improperly
installed PCIe card in the
specified slot number. Reseat the PCIe card in the
specified slot number. See
"Expansion Cards" on
page 70. If the problem
persists, see "Getting Help"
on page 141.
Plug & Play
Configuration Error
Error encountered in
initializing PCI device;
faulty system board. Install the NVRAM_CLR
jumper and reboot the
system. See Figure 6-1 for
jumper location. Check for
a BIOS update. If the
problem persists, see
"Troubleshooting
Expansion Cards" on
page 127. If the problem
persists, see "Getting Help"
on page 141.
Read fault
Requested sector
not found
The operating system
cannot read from the
diskette or hard drive, the
system could not find a
particular sector on the
disk, or the requested sector
is defective. Replace the diskette.
Ensure that the diskette
and hard-drive cables are
properly connected. See
"Troubleshooting a USB
Device" on page 110 or
"Troubleshooting a Hard
Drive" on page 124 for the
appropriate drive(s)
installed in your system.
Remote
Configuration
update attempt
failed
System could not
implement Remote
Configuration request. Retry Remote
Configuration.
SATA port A/B/C/D
hard disk drive
configuration error
Faulty drive. Parameters
failure. Ensure that the hard drive
cables are properly
connected. See
"Troubleshooting a Hard
Drive" on page 124.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions
book.book Page 24 Wednesday, June 24, 2009 8:21 AM