beautypg.com

Removing the computer stand – Dell Precision 690 User Manual

Page 128

background image

 

7.

Slide the rear of the stand into the rear foot of the computer, and ensure that the alignment guide slides into place.

 

8.

Center the front bar of the stand in the corresponding notch in the front foot of the computer.

 

9.

Carefully set the computer back down; the front bar of the stand should snap into place under the weight of the computer.

 

Removing the Computer Stand

 

 

 

1.

Follow the procedures in

Before You Begin

.


 

2.

Carefully, with the help of an assistant, tip the computer back at a very slight angle from the ground.

 

3.

Pull the front of the computer stand down towards the ground, to release it from the front of the computer.

 

4.

Pull the computer stand toward the front of the computer until the stand is free.

Back to Contents Page

 

CAUTION:

Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before

attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See
your Product Information Guide
for other important safety information.

CAUTION:

The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the

computer tipping over, potentially resulting in bodily injury or damage to the computer.