Dell C1760NW Color Laser Printer - Manual (Page 32)

30 Connecting Your Printer
2 Connect the smaller USB connector into the USB port at the back of the printer.
3 Connect the other end of the cable into a USB port of your computer.
CAUTION: Do not connect the printer USB cable to the USB port available on the keyboard.
Wireless Connection
The specifications of wireless setting function are described below:
You can select a method to configure a wireless setting from the following:
Item Specification
Connectivity Wireless
Connectivity Standard IEEE 802.11b/802.11g/802.11n compliant
Bandwidth 2.4 GHz
Data Transfer Rate IEEE 802.11b mode: 11, 5.5, 2, 1 Mbps
IEEE 802.11g mode: 54, 48, 36, 24, 18, 12, 9, 6 Mbps
IEEE 802.11n mode: 65 Mbps
Security 64 (40-bit key)/ 128 (104-bit key) WEP, WPA-PSK (TKIP, AES), WPA2-PSK (AES)(IEEE
802.1x attestation function of WPA 1x non-corresponds), Mixed Mode PSK
Wi-Fi Protected Setup ® (WPS) *1 Push Button Configuration (PBC), Personal Identification Number (PIN)
*1 WPS 2.0 compliant. WPS 2.0 works on access points with the following encryption types: Mixed mode PSK, WPA-PSK AES, WPA2-PSK
AES, WPA-PSK TKIP, Open (No Security)
WPS-PBC (Wi-Fi | WPS Button) *1
WPS-PBC (Operator Panel Menu) *1
WPS-PIN *2
Auto SSID Setup
Manual SSID Setup
*1 WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) is a method to authenticate and register devices required for wireless con-
figuration, by starting WPS-PBC on the printer with the
(Wi-Fi | WPS) button or operator panel menu, and then pressing the button
provided on the wireless LAN access point (Registrar) or router. This setting is available only when the access point supports WPS-PBC.
*2 WPS-PIN (Wi-Fi Protected Setup-Personal Identification Number) is a method to authenticate and register devices required for wire-
less configuration, by entering PIN assignments in the printer and computer. This setting, performed through access point, is available
only when the access points of your wireless router supports WPS.