Dell C1760NW Color Laser Printer - Manual (Page 116)

114 Understanding the Tool Box Menus
Reports
Purpose:
To print the settings and history information of your printer.
The reports are printed in the paper size specified in printer settings.
Values:
TCP/IP Settings
Purpose:
To display the current settings of TCP/IP (Transmission Control Protocol/Internet Protocol) protocol.
Values:
Printer Maintenance
The Printer Maintenance tab contains the System Settings, Paper Density, Adjust BTR, Adjust Fusing Unit, Color
Registration Adjustment, Adjust Altitude, Reset Defaults, Non-Dell Toner, BTR Refresh Mode, TCP/IP Settings,
and Network Settings pages.
System Settings
Purpose:
To configure the power saving mode, time-out time, job log auto print, mm/inch setting, operator panel language
setting, default paper size setting, and low toner alert message setting.
Values:
Printer Settings Click to print a detailed list of the printer settings.
Device Settings Click to print a detailed list of the device settings.
Job History Click to print the completed jobs history.
Error History Click to print the error history.
Color Test Page Click to print a color test page.
IP Address Mode Displays the method for acquiring the IP address.
IP Address Displays the IP address of your printer.
Subnet Mask Displays the subnet mask.
Gateway Address Displays the gateway address.
Sleep *1 Available Range:
5–30 minutes
Specifies the time taken by the printer before it enters Sleep mode after it
finishes a job.
Deep Sleep Available Range:
1–6 minutes
Specifies the time taken by the printer before it enters Deep Sleep mode
after it goes into Sleep mode.
Auto-Off Timer *2 0: Off Specifies the time taken by the printer before it automatically turns off
after it has entered Deep Sleep mode.
60–1440 minutes
Fault Time-Out 0: Off Disables the fault time-out.
Available Range:
3–300 seconds
Specifies the time taken by the printer before it cancels jobs that stop
abnormally. The print job is cancelled if it times out.