Cabletron Systems HSIM-F6 - Manual (Page 58)

Chapter 4: LANVIEW LEDs
4-2 HSIM-F6 User’s Guide
The following table describes the four possible states of the port A and
port B LEDs of the HSIM-F6.
The following table defines the different conditions that the HSIM-F6 can
be in depending on the status (colors) of the A, B, P, and S LEDs
respectively. Refer to
Section 4.1 for more detailed definitions of the LED
states.
Table 4-2 Port A and Port B LED States and Definitions
Color Definition
Green Valid link to port and port enabled
Amber Port disabled via management
Off No valid link or no cable attached
Red Possible hardware or FDDI ring failure
!
CAUTION
The A and B LEDs will sometimes flash red briefly while
performing diagnostics. If they remain red for several minutes,
however, it could indicate a hardware failure. If the LEDs
remain red, contact Cabletron Systems Global Call Center.
!
CAUTION
If the HSIM-F6 P and S LEDs remain red for several minutes
the HSIM-F6 could have a hardware problem. Contact
Cabletron Systems Global Call Center.