Cabletron Systems HSIM-F6 - Manual (Page 24)

Chapter 2: Installation
2-8 HSIM-F6 User’s Guide
3. Attach the antistatic wrist strap (refer to the instructions outlined on
the antistatic wrist strap package).
4. Remove the hub chassis cover (refer to your specific hub
documentation for instructions on removing the hub chassis cover).
5. Refer to Figure 2-3 and remove the two faceplate mounting screws
and the HSIM coverplate. Save the screws.
6. Refer to Figure 2-3 and remove the two standoff screws. Save the
screws.
7. Place the HSIM behind the hub faceplate.
8. Align the HSIM connector of the HSIM with the pins on the hub.
9. Press down firmly on the back of the HSIM until the pins slide all the
way into the HSIM connector holes.
10. Secure the HSIM-F6 to the module faceplate using the mounting
screws saved in
step 5 .
11. Secure the HSIM-F6 to the module standoffs using the standoff screws
saved in
step 6 .
12. Reattach the chassis cover to the hub, reconnect the power cord, and
reconnect the hub to the network.
Refer to Chapter 3 for instructions on configuring the HSIM-F6 using
Local Management.
NOTE
Ensure that the standoffs on the hub align with the standoff
screw holes on the HSIM.
Ensure that the chassis cover is in place before reconnecting
the power cord.