Cabletron Systems HSIM-F6 - Manual (Page 17)

HSIM-F6 User’s Guide 2-1
CHAPTER 2
INSTALLATION
This chapter contains instructions for the following items:
• Unpacking the HSIM ( Section 2.1 )
• Installing FPIMs ( Section 2.2 )
• Installing an HSIM ( Section 2.3 )
To install the HSIM and FPIMs, you need the following items:
• Antistatic wrist strap (provided with 6C105 chassis or standalone hub)
• Phillips screwdriver
2.1 UNPACKING THE HSIM
Unpack the HSIM as follows:
1. Remove the shipping box material covering the HSIM.
2. Carefully remove the module from the shipping box. Leave the module
in its non-conductive bag until you are ready to install it.
3. Attach the antistatic wrist strap. If the HSIM is to be installed in a
standalone hub, refer to the instructions on the antistatic wrist strap
package. If the HSIM is to be installed in an interface module, refer to
the applicable interface module User’s Guide.
4. After removing the module from its non-conductive bag, visually
inspect the device. If you notice any signs of damage, contact
Cabletron Systems Global Call Center immediately. Refer to
Section 1.3 , Getting Help, for instructions.
!
CAUTION
The HSIM-F6 and the host module or hub are sensitive to static
discharges. Use a grounding strap and observe all static
precautions during this procedure. Failure to do so could result
in damage to the HSIM-F6, host module or hub.