Dell LCD TV W4200 - Manual (Page 29)

Using the On-Screen Display
29
FILE LOCATION: C:\Documents and Settings\solinak\Ƈ¦±\OM update\ch4e.fm
DELL CONFIDENTIAL – PRELIMINARY 10/8/04 – FOR PROOF ONLY
www
.dell.com | support.dell.com
PIP/POP/PBP
You can view two active sources simultaneously using Picture-In-Picture (PIP), Picture-Outside-
Picture (POP), or Picture-By-Picture (PBP).
For POP, you can select from three different POP options:
• POP — One large POP window to the left and a smaller, centered window on the right.
• POP3 — One large POP window to the left and three smaller, vertically-aligned windows on
the right.
• POP12 — One large, centered POP window surrounded by twelve smaller windows.
The remote control offers the following PIP/POP/PBP
options:
•Use the PIP button or the POP PBP button on the
remote control to turn on and off PIP, POP, and PBP.
•If you are in PIP, POP, or PBP mode, use the SWAP
button on the remote control to switch between the two
windows.
• Use the POS button on the remote to change which corner of the screen the PIP window
appears.
In the OSD, you can adjust the Transparency, the Size, and H (horizontal) and V (vertical)
position of the PIP/POP/PBP windows. When you are selecting the horizontal orientation, - moves
the window left and + moves the window to the right. When you are adjusting the vertical
orientation, 0 is at the top of the screen and 100 is at the bottom of the screen.
POP Scan Mode allows you to select Sequential or Float. Float mode plays the source for selected
channels that appear in the windows. Sequential rotates through each window and plays all of the
preselected channels. The rotation mode runs through all the available channels before it starts
again at the lowest channel.
PIP/POP/PBP Compatibility
When using PIP/POP/PBP you can select any of the input sources that appear in the PIP/POP/PBP
windows. The only input sources that cannot work together are HDMI with HDMI, DVI with DVI,
and HDMI with DVI.
DZ101_eUM.book Page 29 Friday, October 8, 2004 2:25 PM