Acronis Migrate Easy 7.0 - User Guide - Manual (Page 34)

Appendix A Hard disks and BIOS setup
34 Copyright © Acronis, Inc., 2000–2007
Warning: Ultra DMA Mode
3/4/5 can be enabled only
when BIOS detects
Shielded 80-pin cable.
F1 Help ↓ Select Item -/+ Change Values F5 Setup Defaults
Esc Exit ←→ Select Menu Enter Select Sub-Menu F10 Save and Exit
Place the marker on the value of the Type parameter ([Auto] in this case) and press
the Enter key to open the list of possible values of this parameter; for example:
None
Auto
User Type HDD
CD-ROM
LS-120
ZIP-100
MO
Other ATAPI Device
Use the Up and Down keys to select the User Type HDD value and press the Enter
key to get to the following screen:
AwardBIOS Setup Utility
Main
Primary Master [User Type HDD] Item Specific Help:
Type [User Type HDD] to select the type
Translation Mode [LBA] of the IDE drive.
Cylinders [………0] [User Type HDD] allows
Head [……0] you to set each entry on
Sector […0] your own.
CHS Capacity 0MB
Maximum LBA Capacity 0MB Warning: Ultra DMA Mode
3/4/5 can be enabled only
Multi Sector Transfer [Maximum] when BIOS detects
SMART Monitoring [Disabled] Shielded 80-pin cable.
PIO Mode [4]
Ultra DMA Mode [5]
F1 Help ↓ Select Item -/+ Change Values F5 Setup Defaults
Esc Exit ←→ Select Menu Enter Select Sub-Menu F10 Save and Exit
Enter the values of Translation Mode, Cylinders, Head and Sector parameters (you
can find them on the case of the hard disk) to finish the initial configuring of the
hard disk with BIOS.