ITC Avoximeter 4000 Whole Blood CO-Oximeter - Manual (Page 43)

ITC AVOXimeter 4000 Operator’s Manual
Using the Printer
An optional printer can be connected by means of the serial port at the rear of the instrument (
page 9). see
ptional printer. Note: Contact your ITC representative to purchase the o
Printing the Current Test Results
1. When the test results are displayed on the screen, press .
Specifying Automatic Printing of Results
test. The instrument can be configured so that results are automatically printed at the end of a
1. Display the “Printer Mode” menu (a submenu of , see page 7).
2. Press followed by to display the automatic printing screen:
3. Press followed by . A confirmation prompt is displayed, and the “Printer
Mode” menu is again displayed.
4. Press to return to the previous menu, if desired.
Changing the Serial Port Baud Rate and Parity
If a computer is being connected to the ITC AVOXimeter 4000, the baud rate and parity of the
seri
mmunication. al port on the instrument may need to be changed to optimize co
1. Display the “Printer Mode” menu (a submenu of , see page 7).
2. Press followed by to display the port parameters:
3. Press and/or to change the baud rate. When the correct value is
displayed, press to advance the cursor to the “Parity” field.
4. Press and/or to toggle between NE,” “ODD,” and “EVEN.” When the
lue is displayed,
“NO
correct va press .
5. Press to confirm the new values. The “Printer Mode” menu is again displayed.
6. Press to return to the previous menu, if desired.
35