ITC Avoximeter 4000 Whole Blood CO-Oximeter - Manual (Page 22)

ITC AVOXimeter 4000 Operator’s Manual
Optional Materials
Item Quantity
Dymo Printer
• 110 V (Part No. SE300-110)
1
• 220 V (Part No. SE300-220)
• UK (Part No. SE300-UK)
e 270) As Nee Printer Pap ded
Charging
Charge the batteries before the system is used for the first time.
Note: The AC Adapter can remain connected all the time.
4. To ensure adequate charge, leave the instrument connected to the AC Adapter
Fully charged batteries will allow the ITC AVOXimeter 4000 to analyze blood samples
contin
tness.
Battery power can be conserved by:
Note: The batteries can suffer from a “memory effect” if they are charged before being completely
c re
d when
the
The me
the stand
be used for a
charged.
1. Display the “Time, Date, and Temperature” menu (a submenu of
r (Part No. 30
h
l
the Batteries
1. Plug the AC Adapter into an electrical service outlet.
2. Connect the AC Adapter cord to the power connector on the rear of the instrument.
3. Allow the battery to charge for at least eight hours.
for a minimum of eight hours. This eliminates the risk of the instrument powering
down during a test.
uously for up to 8 hours when the display is set at medium brigh
● Reducing (or turning off) display backlighting (see page 15).
● Reducing the standby delay (see page 18).
dis
cha harged. For optimal battery performance, discharge completely when possible befo
rging them. The message “Battery Critical – Connect Charger” will be displaye
battery is completely discharged.
ssage “Battery Critical – Connect Charger” is displayed and the instrument reverts to
by mode if t e battery power is insufficient to complete the test. The AC Adapter must
dditiona tests until the battery is re
Checking the Battery:
, see page 7).
2. Press followed by to display the battery status:
14