Humboldt HM-3000.3F Digital MasterLoader - Manual (Page 27)

24
* RECALL CALIBRATION
* CHANGE DEVICE ID
* DATE/UNIT/STANDARD
* MANUFACTURES INFO
Press (CHANGE DEVICE ID). You should see this screen:
Press
to increase the ID number or press to decrease the
number. Once the ID has been changed, press to go back to previous
menu. Note: Up to 16 devices can be connected to a single computer.
SENSOR LIMITS
Sensor upper limits can be set to ON or OFF. If the Sensor’s Upper
limit is set to ON and the motor/test is in progress, when the sensor
reaches its upper limit, the motor/test will stop and a warning message
will be displayed. In addition, if a sensor has been unplugged from the
instrumentation back panel, the same warning message will be displayed.
RAW_DATA
RAW-DATA refers to the digital output of the sensors prior to apply the
calibration factor and conversion into engineering units.
Standard Tests
CBR/LBR
First center the CBR mold on platen with the first surcharge weight in the
mold. Press the
button to raise the mold close to the penetration
piston. There should be about a 1/8" (3.000mm) gap between the specimen
and the piston.
Press
You should see this screen:
DEVICE ID = 1
* INCREASE
* DECREASE