Humboldt HM-3000.3F Digital MasterLoader - Manual (Page 19)

16
Press (SPEED) to move between the numbers. Keep pressing
until the digit you want to change is flashing. Once you have selected
the number you want to change, press
(INCREASE) or
(DECREASE) to change the number to the desired value.
Set Logging Interval
To set or change the logging interval for USER DEFINED TEST press
until the following setup screen appears:
Press you will see this screen:
Press (ENGINEERING SETUP). You should see this screen:
Press (LOGGING INTERVAL). You should see this screen:
Press (TIME) to cycle between the hour/minute/second/tenths to
select the desired increment. Press (INCREASE) to
(DECREASE) to change to the appropriate number
* REVIEW LAST TEST
* RUN TEST
* MORE SETUP
* ENGINEERING SETUP
* SENSOR LIMITS OFF
* RAW_DATA
* MORE SETUP
* CONFIGURATION
* CALIBRATION
* LOGGING INTERVAL
SAMPLE LOGGING TIME
* TIME = HH:MM:SS.T
* INCREASE
* DECREASE